HOLDEN FB RETRO
The Holden FB Retro is an automobile that was produced by Holden in Australia from 1960 to 1961. Introduced on 14 January 1960, the Holden FB Retro series replaced the Holden FC range.
The FB range consisted of four-door sedans in two trim levels, five-door station wagons in two trim levels, a two-door coupe utility and a two-door panel van. The six models were marketed as follows: Holden Standard Sedan, Holden Standard Station Sedan, Holden Special Sedan, Holden Special Station Sedan, Holden Utility and Holden Panel Van.
The Holden Business Sedan, which had been marketed as part of the FC range, was not carried over to the FB series.
The FB was promoted as being longer, lower, more spacious and more powerful than the FC model although in reality it was only slightly so on each count.mOverall length was 5.5 inches (140 mm) greater whilst the wheelbase remained the same. The engine remained the same at 3″ the last model to have this bore, engine capacity remained at 132 cubic inches and the compression ratio was raised. However the resulting extra 4 brake horsepower (3.0 kW) of power did not compensate for the extra weight of the FB and performance was thus inferior to that of its predecessor. Changes were also made to the brakes, front coil springs, air cleaner and clutch.
Obvious styling differences were the lower bonnet, finned rear mudguards with new taillights (on the sedans and wagons only) and a wrap-around windscreen. Seating was improved as was the instrument panel.
Please choose carefully and refer to the terms and conditions for sizing as these shirts are print to order and will not be exchanged.